SPORTSTECH CX2 Manuel page 28

Step 3:
1. Insert the Flywheel Axle (25) through the Vertical Frame (15) and slide 1 washer (27) onto the axle
from both sides (2 pieces in total).
2. On the left side of the cross trainer, slide the pre-assembled Swing Tube (44) onto the Axle (25) on
the vertical frame and slide the Pedal Frame (50) onto the foot pedal axle on the Main Frame (69).
Fasten the Flywheel (44) with 1 washer (30), 1 spring washer (11) and 1 screw (31). Screw the
Pedal Frame (50) tight with 1 washer (109), 1 spring washer (11) and 1 screw (108) and press the
cap (107) onto the foot pedal axle.
3. Repeat the process on the right-hand side with the pre-assembled Flywheel (28) on the Axle (25)
and the Pedal Frame (94) on the foot pedal axle.
4. Place the Pedal (62) on the Left Pedal Frame and the Pedal (95) on the Right Pedal Frame. Insert 2
screws (35) through the pedals from above and screw them tight from below with 2 washers (114)
and 2 handle nuts (126).
2
1
4
28
3