Installation; Preparation; Important Points To Note While Relocating Your Refrigerator; Before Operating The Refrigerator - Beko BU 1100 HCA Mode D'emploi

3

Installation

C
Please note that the production
company cannot be held responsible
when the instructions in the manual
are not followed.

Preparation

• Your refrigerator must be placed with
at least 30 cm distance from heat
sources like burners, ovens, radiators
and stoves, and with at least 5 cm
distance from electrical ovens, and
it must not be placed under direct
sunlight.
• The temperature of the room where
your refrigerator is placed must be at
least 10°C. It is not recommended
to operate your refrigerator in colder
environments for performance
purposes.
• Please make sure that the interior
of your refrigerator is cleaned
thoroughly.
• If two refrigeration units are being
placed side by side, there must be
at least 2 cm clearance between the
units.
• When starting up your refrigerator for
the first time, note the following points
for six hours.
- The temperature setting button
mustn't be switched off.
- The door must not be opened too
frequently.
- It must be operated empty, without
putting food into refrigerator.
Do not pull the plug out from
the power socket; if there is any
undesired power blockout, note the
warnings in the "Solution Suggestions
for Problems" section.
• The original package and styrofoam
must be kept for future transfer and
moving of your product.
Important points to note
while relocating your
refrigerator
1. Your refrigerator must be emptied
and cleaned before moving the
product.
2. The shelves, accessories, crisper, etc.
in your refrigerator must be wrapped
and reinforced against shaking before
packing it again.
3. The package must be fixed with
thick tapes or strong strings, and the
safety rules on the packing must be
followed.
Please Note...
Each recycled item is an indispenseble
source for the nature and our national
wealth.
If you would like to contribute to
the recycling of package materials,
you may get information from
the environmental instutitions or
municipalities.
Before operating the
refrigerator
Before starting to use your refrigerator
check the following.
1- Is the interior of the refrigerator dry
and can the air circulation be made
easly in the back part?
2- Clean the interior of the refrigerator as
recommended in "Maintenance and
cleaning" section.
3- Insert the plug of the refrigerator into
the wall socket. The related interior
lighting will be switched on when the
door is opened.
4- You will hear a sound when the
compressor starts operating. The
pressed coolants in the cooling
system may create a noise even if
the compressor is not operating, and
this is very normal. The general noise
8
EN