Care And Maintenance; Cleaning The Balance - Sartorius Secura Notice D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
B
A
Put packing pads over the glass
t
panels
Insert the AC adaptor from the
t
cardboard box into the packing pad.
Put the top part of the packaging
t
over the device parts.
Next, put the packaged balance into
t
the cardboard box and seal the box.
8
Installation and Operating Instructions Secura
Place the following parts
t
into the bottom part of the
packaging:
Draft shield
Balance
Base plate
Side panels
Top glass cover
Insert the respective
t
weighing pan and pan
support into the opening
shown in the image to the
left:
– A = Weighing pan and pan
support with a diameter of
120 mm
– B = Weighing pan and pan
support with a diameter of
90 mm
®
®
®
, Quintix
, Practum

Care and Maintenance

Service
To ensure the continued accuracy of your balance, we recommend
scheduling regular servicing at least once a year. Sartorius Service
offers different service contracts with maintenance intervals that are
tailored to your needs. A calibration certificate should be issued as
part of every maintenance session. Safety inspections of the AC
adaptor and its connections must be performed at appropriate
intervals by a qualified electrician (e.g. every 2 years).
Repairs
Repair work must only be carried out by trained
service technicians. Repairs performed by untrained
persons will invalidate the warranty, and may result in
consider able hazards for the user and cause the bal-
ance to produce inaccurate results. Contact Sartorius
Service or a Sartorius dealer for proper repair of your
balance. The device must be unplugged during repair
work. Unplug the power cord. Repair work must only
be performed by Sartorius-trained service technicians.

Cleaning the Balance

Cleaning the Control Panel
Switch the display to Standby mode to avoid modifying the settings
for operation during cleaning.
Touch the "Menu" key to switch to application
t
selection.
If you then touch E, the display goes off.
t
To switch the display back on again:
t
Select j at the bottom left of the display.
Cleaning the Balance Housing
Disconnect from the power supply:
Unplug the AC adaptor from the mains. If necessary,
disconnect the data cable connected to the balance.
Never open the balance or the AC adaptor.
The parts contained in these cannot be cleaned,
repaired, or replaced by the operator.
– The parts contained in these cannot be cleaned, repaired,
or replaced by the operator.
– Remove the base plate, pan support, and weighing pan from the
wind shield.
– Never use cleaning agents that contain solvents or abrasive
ingredients, which can ultimately damage the equipment.
®
®
Secura
and Quintix
-Models:
The plastic top and bottom parts of the balance housing are
t
coated with a special substance that allows these parts to be
cleaned using acetone.
Do not clean the following parts with acetone or
aggressive cleaning agents: control panel, mains
plug, data interface, labels, verified seal, or any other
plastic parts.
Wipe the balance with a soft, dry cloth after cleaning.
t

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

QuintixPractum

Table des Matières