Changing The Fuse - GRAVOGRAPH IS Serie Guide D'utilisation

Changing the fuse

You will find a spare fuse (F2) in the drawer (T) containing the fuses of the chips collector IS.
The chips collector is protected by one fuse 5 A (T*) - 250V (F1).
(T*) = These fuses must be temporized, with a high breaking capacity and must
comply with the IEC 127-2 norm.
Unplug your mains cable from the mains socket.
1. Disconnect the mains cable (D) from the socket (A5) at the back of the chips collector IS to
give easier access.
2. Pull out the drawer (T) containing the fuses (F1) and (F2).
The fuse (F1) must be replaced by the spare fuse (F2).
3. Replace the fuse (F1) and close the drawer (T) again.
If the new fuse blows without apparent reason, contact an approved
GRAVOGRAPH technician.
IS CHIPS COLLECTOR • 38