Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mirrored text
You can also print mirrored text. You may for example want
to stick a transparent label on the inside of a glass door.
Press MIRROR (
+
highlighted, showing that the mirror function is enabled.
ALIGNING TEXT IN A LABEL
You can choose to align your text within a label. This func-
tion will add the blank part of the tape in different ways;
your text
left aligned:
your text
centred:
your text
right-aligned:
MULTIPLE LINES
Press
to start the next line of text on a multi-line label.
↵
This is a two
line label on the display will be printed as:
This is a two
line label
and the display will indicate two lines:
You can print up to five lines on one label.
Tape width
1"
24mm
3/4"
19mm
1/2"
12mm
3/8"
9mm
1/4"
6mm
JUSTIFYING TEXT IN MULTI-LINE LABELS
For multi-line labels, you can choose three options for your
text alignment: left-justified, center-justified, or right-justi-
fied. Press JUST (
between these three options, which are shown on the left of
the display.
left justified
centred
right justified
). The
indicator will be
Font
Alignment indicator
[=
[=]
=]
Maximum number
of lines
5
5
3
3
1
+
)repeatedly to toggle
STAIRCASE
emergency lighting
BX-243
STAIRCASE
emergency lighting
BX-243
STAIRCASE
emergency lighting
BX-243
WORKING WITH TABS
Adding tabs to a label
You can add tabs within a label if you want to line up your
text over different lines. To enter a tab, press TAB. The
default length is 2". Tabs are only left-justified.
text
SETTING A FIXED LENGTH FOR YOUR LABELS
Normally the length of your label depends on the length of
your text. You may wish to print a series of labels of the
same length - perhaps to label files or folders. The FIXED
LENGTH function allows you to set a fixed length for the
label. To set a fixed length, press
cator (
) will be highlighted. The last fixed length used
by the printer will appear on the display, for example:
1.6"
You can change this setting in two ways.
• Either use the P or H keys to increase or decrease the
setting in steps of 1/24".
• Or key in the number using the number keys, starting
from the right-hand digit. Use Q to move one digit to
the left. Press
Note if your fixed length is shorter than the text of your
label, an error message will flash.
To return to the automatic length mode, press
and the machine will return to the automatic length setting.
The fixed length indicator will no longer be highlighted.
PRODUCING A BAR CODE
The LabelMANAGER 400 can generate bar codes in the six
standard barcode formats: EAN-13, EAN-8, UPC-A, UPC-E,
CODE-39 and CODE-128.
Barcodes can be printed on 3/4" and 1" wide labels only and
can be either full height or mixed with one line of text.
To create a bar code:
• Press
to display the barcode type previously
Bcode
selected.
• Press
to return to the current label, or
Cancel
• Use P or H to step through the barcode types available:
EAN-13, EAN-8, UPC-A, UPC-E, CODE-39 and CODE-128.
• Press
to select the barcode type displayed. The bar-
code indicator will light in the display and the symbols
and
will appear at each end of the space allocat-
ed for barcode characters.
• Enter the characters which will become the barcode,
e.g.: 1234567.
• Press
to return to the label.
7
text
. The fixed length indi-
to confirm.
again,
Publicité
Table des Matières
