Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
SAVE THESE
INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
INTENDED USE
This appliance is designed for professional outdoor
blower applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This appliance is a professional power tool. DO nOT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and unplug before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
CAUTION: The tube must be attached to the
housing
before use.
9
1. TUBE AssEMBlY:
To attach the tube
to the blower, line
up the pegs
10
on the bottom of
the tube with the
notch
11
on the
bottom of the
housing opening
as shown in
figure C. Push the tube into the blower housing until the
lock engages the tube.
4
no ....................... no load speed
n ......................... rated speed
...................... earthing terminal
...................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
fig. C
9
11
12
2. Pull on the tube to ensure it is securely in place.
3. To remove the tube, insert a screwdriver into the
unlocking hole
tab inside and pull tube out.
Attaching Nozzles (Fig. D)
1. Line up the channels
8
with the nubs
2. Slide the nozzle onto the tube.
3. Firmly twist the nozzle to lock the nubs completely into
the recesse of the nozzle. Ensure the nozzle is securely
attached.
fig. D
Attaching Extension Cord To Blower
(Fig. A, E)
WARNING: Do not use with tube removed.
WARNING: Ensure the trigger switch is not engaged to
reduce the risk of starting the appliance accidentally.
1. Near the end of the extension cord
extension cord to create a loop.
2. Feed the loop into the bottom hole
retainer
5
3. Slide the loop over the hook
it rests fully in the cord retainer.
4. Plug the extension cord into the power head
OPERATION
4
WARNING: Do not operate blower without tube
securely in place. Never reach down into housing
through tube hole.
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personal injury,
10
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
on the side of the housing. Lift the
12
13
of the desired nozzle
14
on the tube
4
14
as shown in figure E.
17
of the cord retainer so
fig. E
16
17
18
6
,
7
, or
.
13
6
15
, fold the
16
of the cord
18
.
15
Publicité
Table des Matières
