Unpacking; Disposal Of The Packaging; Setup Location Requirements; Electrical Connection - CASO DESIGN Coffee Compact Mode D'emploi

► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

12.3 Unpacking

To unpack the device, proceed as follows:
 Remove the device out of the carton and remove the packaging material.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging materials are
selected in accordance with environmentally compatible and recycling-related points of view and
can therefore be recycled. Returning the packaging back to the material loop saves raw materials
and reduces the quantities of accumulated waste. Take any packaging materials that are no longer
required to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

12.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 Only use this device on a flat, stable, heat-resistant surface away from water splashes
and any heat sources. Never use the device outdoors and always place in a dry
environment.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations must be
carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
Please note
Please note
46