Ptz Control (All Ch Mode); Ip Device Search - Avtech AVH312 Mode D'emploi

5.4 PTZ Control (All CH mode)

Note: This function is available only for "SUPERVISOR" and "POWER USER". To know more details,
please refer to "4.4 User Level Creation" at page 12.
Click on the quick menu bar to display the panel as follows:
/ / /
/
/
/
/
*To know how to configure NVR with video server, please refer to the user manual of video server.

5.5 IP Device Search

Note: This function is available only for "SUPERVISOR". To know more details, please refer to "4.4 User
Level Creation" at page 12.
Click (IP Search) to start search IP camera(s) connected in the same network segment as the NVR (i.e.
10.1.1.xx by default).
You'll see the list of every connected IP camera with its connection status to this NVR and MAC address.
IP PORT
10.1.1.12 88
10.1.1.13 88
10.1.1.14 88
10.1.1.15 88
10.1.1.16 88
10.1.1.17 88
10.1.1.18 88

Up / Down / Left / Right
Enter
Iris + / Iris -
Zoom in / out max
Zoom in / out
Focus near / far
Auto pan
Auto tracking
Preset point
Camera Menu
IP SEARCH
MAC STATUS
00:0e:53:e5:9a:f1 CONNECTED TO CH1
00:0e:53:a6:91:18 CONNECTED TO CH2
00:0e:53:a5:9f:a2 UNUSED
00:0e:53:e1:4e:k5 CONNECTED TO CH3
00:0e:53:s5:3e:h6 CONNECTED TO CH4
00:0e:53:e6:4b:26 CONNECTED TO CH5
00:0e:53:g2:3b:e7 CONNECTED TO CH6
CONNECT
Click to move your selection up / down / left / right, or change settings.
Click to confirm your selection / enter the menu.
This two buttons are designed for PTZ camera. To know the action after
clicking Iris + and Iris -, please refer to the camera's user manual. If you
using an analogue camera, paired with Video Server*, make sure the
camera and Video Server support P-D / P-P protocol for PTZ control.
Click to zoom in on the image to the largest / zoom out on the image to its
original size.
Click to zoom in / out the image.
Click to adjust the focus of the image.
Click to activate the auto pan.
Before using it, you need to assign a specific function that will be enabled
when "AUTO" is clicked. For details, please refer to the user manual of
the PTZ camera.
Click to activate the auto tracking.
Before using it, you need to assign a specific function that will be enabled
when "AUTO" is clicked. For details, please refer to the user manual of
the PTZ camera.
Click to enter the PTZ preset point you want to see.
Click to enter the camera main menu.
For details about each camera menu, please refer to the user manual of
the PTZ camera.
SETUP EXIT
18
QUICK OPERATION