Ptz Control (1Ch Mode) - Avtech AVH312 Mode D'emploi

Function
 Playback control
Fast Forward
Fast Rewind
Play / Pause
/
Stop
Slow Playback
Previous / Next Hour
/
Quick Search

4.5 PTZ Control (1CH mode)

Note: This function is available only for "SUPERVISOR" and "POWER USER". To know more details,
please refer to "4.4 User Level Creation" at page 12.
Click on the channel status bar to display the panel as follows:
How to set a preset point:
Step1:
How to go to a preset point:
Step1:
Up / Down / Left / Right
/ / /
Digital zoom in / out
/
Focus near / far
/
Preset point
Step2: Select the numbering within which saves the camera view you want to
see, and wait till you see
disappearing on the NVR status bar.
User Level
SUPERVISOR POWER
 
 
 
 
 
 
 
Click to move your selection up / down / left / right, or
change settings.
Click to zoom in / out the camera image digitally.
Click to adjust the focus of the image.
Click to display the preset point panel for preset point
viewing or setting. For details, please refer to the section
below.
Step2: Click or
click
/ /
want to configure as a preset point.
Step3: Click the numbering you want to configure for this
point, and wait till you see
appearing and disappearing on the NVR status bar.
Step4: Repeat from Step1 again to set other points if
needed, or click
selection panel
(command sending) appearing and
13
FREQUENTLY-USED FUNCTIONS
NORMAL GUEST
to the proper ratio you need, and
to move to the point you
/
(command sending)
to return to the preset point