Let's Go Aero GearDeck H00604 Manuel Du Produit page 9

STEP 18
REQUIRED TOOL: 3/8" WRENCH & PHILLIPS SCREW DRIVER
Install one (1) Rubber Latch [PP] onto each
side of the Fixed Lid [BB] using two (2) 10x24-1
Phillips Pan Screw [KK], two (2) #10 Washers
[LL] and two (2) 10-24 Nylock [NN] on each
side. [Fg. 31]
NOTE: Though only one bolt is shown in Fg. 34
for clarity, two (2) Phillips Pan Screw [KK] per
latch are needed.
STEP 19
REQUIRED TOOL: 3/8" WRENCH & PHILLIPS SCREW DRIVER
Install Handle [DD] onto the Pivot
Lid [CC] (with the GearDeck Logo)
where holes have been pre-drilled
using 10x24-1 Phillips Pan Screws
[KK] secured on the inside with 3/16"
x 1" Fender Washers [MM], and 10-24
Nylock Nuts [NN]. [Fg. 32]
STEP 20
REQUIRED TOOL: 3/8" WRENCH & PHILLIPS SCREW DRIVER
Install one Latch Keeper
[RR] onto each side of
the Pivot Lid [CC] where
holes have been pre-drilled
using 10x24-1 Phillips Pan
Screws [KK] secured on
the inside with one (1) #10
Washer [LL] and one (1)
10-24 Nylock Nuts [NN].
[Fg. 34]
NOTE: The Latch Keeper [RR] must be
installed so that the Latch Keeper points
toward the GearDeck logo on the front
of the lid as shown. [Fg. 33]
[Fg.31]
LL
RR
NN
KK
CC
[Fg.34]
BB
PP
KK
NN
MM
Page 9 of 19
LL
NN
CC
DD
KK
[Fg.32]
[Fg.33]