Let's Go Aero GearDeck H00604 Manuel Du Produit page 10

STEP 21
Slide hinges on the
Pivoting Lid [CC]
over the hinge posts
on the fixed Lid [BB]
and close the lid. [Fg.
35 & 36]
NOTE: A slight offset is provided on the Driver Side
hinge as an alignment aid to attaching and removing
the pivoting lid to the fixed lid.
Vehicle and Hitch Receiver Compliance
This Carrier fits 2" size hitch receivers and is rated for a Class II tow capability or higher. Before using this product, consult your vehicle
and hitch receiver owner manual(s) for details on your tow and tongue weight parameters. Be sure that they are compatible with carri-
er's weight specifications. Never exceed vehicle or hitch weight limits.
Carrier Weight and Load Parameters
The GearDeck weighs 80 lbs unloaded. To determine your available load weight in accordance with your vehicle and hitch receiver's
tongue weight rating, subtract GearDeck's 80 lbs from your identified tongue weight rating. The difference represents your vehicle and
hitch receiver's available load weight.
The GearDeck is rated for up to 420 lbs of cargo weight carrying capacity for a combined weight of 500 lbs when fully weight loaded.
Sliding Out Carrier & Clearance Adjustability
To telescope the GearDeck, remove the Silent Hitch Pin® with Handle from the Slide Tube's Safety pin hole. Verify that the Safety Ca-
ble is secured and then slide the frame to the rear. When adjusting the position of capsule clamps for added clearance needs, be sure
to adhere to NO USE AREA distance of 3.5 inches rearward from Spine's vertical plate along the frame tubes.
Lighting
Connect the 4-flat wire plug to vehicle trailer lighting. Check running lights, brake lights, and turn signals before operation. Check the
wire harness for good connections and for possible fraying or wearing of insulation if a light signal is not functioning. Check lights before
each use.
Closing Lid & Lock Up
Always secure draw latches on both sides of GearDeck before transit. A hole is tapped on the Pivot Lid and Tray for use of a lock (not
included). A padlock works well.
Always check and confirm all bolts and connections are tight and fully secured and Rubber Latches are fully secured over the
Pivoting Lid of the carrier before transit. Failure to follow proper installation and equipment checks before transit may result in
Car vehicle exhaust can cause a hazard. As a precaution, position carrier clear of exhaust.
[Fg. 35]
CC
Let's Go Aero Systems Three-Year Limited Warranty
For information and to register online at www.LetsGoAero.com/warranty
damage to carrier, damage to property, bodily injury or death.
[Fg. 36]
BB
WARRANTY:
WARNING:
CAUTION:
Page 10 of 19