Let's Go Aero GearDeck H00604 Manuel Du Produit page 4

STEP 6
REQUIRED TOOL: 1/2" WRENCH
On the side of the base that is closest to the
vehicle, in the same manner as STEP 5, attach
the remaining Wing [N] to the Slide Tube [M]
using two (2) Hat Bracket Assemblies [P, Q, T, &
U], adding the "looped end" of the Safety Cable
[R] between the Hat Bracket and Wing on one
side only. [Fg. 9]
IMPORTANT: The Safety Cable [R] must be
placed on the interior of the Slide Tube [M] and
on the side of the Wing [N] that is closest to the
vehicle.
Hand tighten only at this time, further
adjustment will be required before final
assembly (see STEP 10).
STEP 7
Insert the Handle Silent Hitch Pin with Handle and Plastic Bushing [D, G]
through the end with Spring Nut [H] installed in STEP 2, engage threads,tighten
firmly and secure with Retainer Clip [B]. [Fg.10]
NOTE: The Silent Hitch Pin with Handle [D] controls the slide-out function of the
platform. Once installation is complete, the Silent Hitch Pin with Handle may be
removed in order to slide the carrier rearward for rear hatch access when vehicle
is stationary.
Never operate the vehicle without the Silent Hitch Pin with Handle fully secured. Failure to follow proper procedures
STEP 8
Install the Reflector End Caps [S] over both ends of each Slide Tube
[M] and secure with one (1) #10 K-Lath Tex Screw [ZZ] each. [Fg.11]
TIP: Reflector End Caps are a tight fit.
WARNING:
may result in bodily injury and property damage.
Page 4 of 19
N
Q
P
T
U
M
M
ZZ
[Fg. 9]
M
R
G
H
D
B
[Fg. 10]
[Fg. 11]
S