Controlling Auxiliary Equipment In "Inverse Mode; Connecting Controller To Ballasts; Connecting Controller To Complete Systems; Connecting Controller To Main Power Supply - Eye Hortilux GRC1 Manuel D'utilisation

4.4 Controlling Auxiliary Equipment in Inverse Mode (two rooms 12h/12h)
CAUTION! EYE HORTILUX® recommends you install and connect the EEM before plugging it into the
main power supply. Not doing so can cause the auxiliary equipment to start immediately.
Note: Two EEMs are needed for a two room setup.
Note: When activated, the blue light on the controller will illuminate.
1. Link one EEM cable to the controller cage clamps marked "EEM1" and a second EEM cable to the
controller cage clamps marked "EEM2. " (see Figure 7)
2. Connect the auxiliary equipment to the EEM cables.
4.5 Connecting the Controller to Ballasts
WARNING! When connecting the DE system to the controller, the system may power on. Make sure your
system(s) are not connected to the main power supply or the signal cable of the ballast is not inserted in
the controller.
WARNING! The controller may only be connected to compatible EYE HORTILUX ballasts and systems.
WARNING! Do not drape power cords over the reflector to avoid damage to cord.
1. Make sure your system(s) are not connected to the main power supply.
2. Switch the rotary knob on all ballasts to "EXT" (external control)
3. Plug the RJ9 end of one of the controller cables into the RJ9 main port of the controller.
4. Plug the RJ14 end of the controller cable(s) into one of the two RJ14 ports of the first ballast.
5. Interconnect the remote ballast to the next ballast in line using an interconnect cable with RJ14 plugs.
Up to 50 ballasts may be daisy-chained in this way.
6. Plug system(s) back into the main power supply.
4.6 Connecting the Controller to Complete Systems
WARNING! The controller may only be connected to compatible EYE HORTILUX ballasts and systems.
Note: An RJ14 splitter and two cables are provided with each complete EYE HORTILUX system since complete
systems have only one RJ14 port.
1. Switch the rotary knob on all EYE HORTILUX systems to "EXT. "
2. Plug the RJ9 end of the provided controller cable into the RJ9 main port of the controller.
3. Plug the RJ14 end of the controller cable(s) into the input of a RJ14 splitter. Use an interconnect cable to
connect one output of the RJ14 splitter to the RJ14 port of the ballast.
4. Use an interconnect cable to connect one output of the RJ14 splitter to the input of the following
RJ14 splitter.
5. Repeat this process to connect up to 50 ballasts.
4.7 Connecting the Controller to the Main Power Supply
WARNING! When you plug in the controller, the connected ballasts may ignite. Make sure your ballasts
are not connected to the main power supply yet or the signal cable of the ballasts is not inserted in the
controller yet.
Note: An RJ14 splitter and two cables are provided with each complete system since complete systems have only
one RJ14 port.
1. Plug the adapter to the AC outlet.
2. Plug the DC connector of the adapter into the DC inlet of the controller. The green power indicator will
start blinking to indicate the power was interrupted.
3. Hold the BACK button for 3 seconds. The green power indication will start to illuminate continuously.
4. Plug ballasts back into the main power supply.
8
Visit eyehortilux.com for the latest installation instructions.