7: Interpreting Controller Information; Reading The Default Screen; Showing System Time; Interpreting Led Signals - Eye Hortilux GRC1 Manuel D'utilisation

7. INTERPRETING CONTROLLER INFORMATION

7.1 Reading the Default Screen

A B
The default screen displays the temperature measured by one or two temperature sensors (Figure 14A).
The screen also displays the output of both its channels, either in % or in Watts (Figure 14B). If an error
occurs, it may also be displayed. (See sections 7.3 and 7.4 for potential error messages)
7.2 Show System Time
1. Press the up key when in the default screen to show the system time.
2. Press the up key again to return to the default screen.

7.3 Interpreting LED Signals

B
A
C
GREEN LIGHT (Figure 15A)
A glowing green light indicates the controller is functioning.
A blinking green light indicates the power has been interrupted. After a power failure, the blinking green
indicator must be reset:
1. Hold the BACK button for three seconds to reset the indicator.
BLUE LIGHT (Figure 15B)
A glowing blue light indicates the connected ballasts are activated.
A blinking blue light indicates an overload. (see section 7.4)
When a blue light is off, it indicates the connected ballasts are deactivated.
14
Visit eyehortilux.com for the latest installation instructions.