2: Safety Guidelines; 3: Warranty; 4: Installing Controller; Mounting Controller - Eye Hortilux GRC1 Manuel D'utilisation

2. SAFETY GUIDELINES
WARNING! The EYE HORTILUX® GRC1 controller may only be used to control compatible EYE HORTILUX
ballasts. Do not connect the controller to other products as this may cause a malfunction including fire or
risk of harm to person or property. Doing so will void the warranty.
WARNING! Do not open or disassemble the controller, it contains no serviceable parts. Opening the
controller will void its warranty and may cause electrical shock.
Keep the controller away from fire, excessive heat, moisture, water, dust and contamination.
Always install lamp before connecting the system to the main power supply. Refer to the EYE HORTILUX
DE 1000-VS installation instructions for proper use.
3. WARRANTY
2-year warranty from the date of purchase.
EYE Lighting International of North America ("EYE Lighting") warrants the mechanical and electronic
components of the EYE HORTILUX controllers to be free from defects in material and workmanship
provided that such controllers are operated under normal operating conditions for a period of (2) years
from the original date of purchase. If the product shows any defects within this period and that defect is
not due to user error or improper use, EYE Lighting shall, at its discretion, either replace or repair the system
using suitable new or reconditioned parts.
All warranty claims must be directed to the retail store where the EYE HORTILUX product was purchased.
LIMITATION OF LIABILITY
The warranty and remedies set forth herein are in lieu of any and all other warranties express or implied,
including any warranty of merchantability or fitness for a particular purpose . In the event of a breach
of warranty, EYE Lighting International of North America ("EYE Lighting") shall, in its sole discretion,
repair or replace the non-conforming product or refund the purchase price within a reasonable time .
EYE Lighting shall not be obligated or liable for any indirect, consequential, or incidental damages for
breach of this or any other warranty, express or implied, or for any claim based on contract, tort, or any
other legal theory . In no event shall EYE Lighting's liability exceed the purchase price of the product .
4. INSTALLING THE CONTROLLER
4.1 Mounting the Controller
WARNING! The area in which the product is placed must comply with the conditions specified in
section 1.2.
CAUTION! Only mount the product on a sturdy, solid surface.
1. Determine the optimal location for the controller.
2. Carefully remove the mounting plate from the controller.
3. Hang the mounting plate against the desired surface using #6 x 1" flat-head screws.
4. Secure the controller into the mounting clamp. Controller should click into place when properly secured.
4.2 Installing the Temperature Sensor in
Follow Mode (one room)
Only one of the provided temperature sensors is needed in
Follow Mode.
1. Place the provided temperature sensor as close as possible
to the sensor of the existing climate control system, so both
sensors will measure the same temperature (Figure 6A)
2. Ensure the sensor is covered from the light, as this
will disrupt temperature measurements. Use a hood if
necessary (Figure 6B).
3. Insert the plug of the temperature sensor into the T1 port
(Figure 6C)
4. The temperature measured by the sensor will be displayed
on the controller display.
6
Visit eyehortilux.com for the latest installation instructions.
Climate control system
C
B
A