Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Playback
Scene Playback
Manual Scene
Playback (Single)
Auto Bank Playback
Music Bank
Playback
Chase Playback
Auto Chase
Playback
Music Chase
Playback
Playback Modifications
MIDI Operation
Page 14 of 44
This controller is capable of playing back a single scene at a time. The <SPEED>
and <FADE TIME> faders will not function in this mode. Please see the instructions
below for further explanation.
1.
Set the controller in [MANUAL] playback mode. If [AUTO] or [MUSIC] is visible on the
display, press the appropriate button(s) to disable the mode(s). When these modes are
disabled, the controller will be in manual scene playback mode.
2.
Using <BANK UP/DOWN>, navigate to the appropriate bank of the desired scene.
3.
Activate the appropriate scene by pressing <SCENE 1~8>.
4.
Activate another scene, if desired. This will disable any previously selected scene.
This controller is capable of playing back all 8 scenes on one of the 30 banks. These
scenes will play back in sequential order. The <SPEED> and <FADE TIME> faders
are used to control the transition between the individual scenes. Please see the
instructions below for further explanation.
1.
Press <AUTO/DEL> to set the controller in [AUTO] playback mode.
2.
Using <BANK UP/DOWN>, navigate to the appropriate bank of scenes.
3.
Use the <SPEED> and <FADE TIME> faders to adjust the scene transition.
The scenes will play in sequential order within the bank. Only programmed
scenes will play back. Empty scenes will be skipped during playback.
This controller is capable of playing back all 8 scenes on one of the 30 banks. These
scenes will play back in sequential order. The triggering from one scene to another
will be synchronized to the beat of the music. Please see the instructions below for
further explanation.
1.
Press <MUSIC/BANK COPY> to set the controller in [MUSIC] playback mode.
2.
Using <BANK UP/DOWN>, navigate to the appropriate bank of scenes.
The scenes will play in sequential order within the bank.
Only programmed scenes will play back. Empty scenes will be skipped during
playback
There are three different modes of playback for the chases in the Obey™ 40. Please
see the sections below for detailed instructions on these modes.
You may activate multiple chases in this controller. They will play back in
sequential order.
You may control the playback of the chases in this controller by using the <SPEED>
and <FADE TIME> faders. Please see the instructions below for further explanation.
1.
Activate the desired chase by pressing <CHASE 1~6>.
2.
Press <AUTO/DEL>.
3.
Using the <SPEED> and <FADE TIME> faders, adjust the playback speed and transition
between the individual scenes (steps).
You may synchronize the playback of the chases in this controller to the beat of the
music. Please see the instructions below for further explanation.
1.
Activate the desired chase by pressing <CHASE 1~6>.
2.
Press <MUSIC/BANK COPY>.
The controller will only respond to MIDI commands on the MIDI channel when it is
set to full stop. Perform all MIDI control using Note on commands. All other MIDI
instructions are ignored. To stop a chase, send the blackout on note.
The controller is always in MIDI receive mode. It is not necessary for the
display to read [MIDI] for the controller to respond to MIDI commands.
Obey™ 40 User Manual Rev. 5 ML
Publicité
Table des Matières
