Copying Physical Fader Assignment; Fader Reverse (0~255/255~0); Resetting The System - Chauvet Obey 40 Mode D'emploi

Copying Physical
Fader Assignment
Fader Reverse
(0~255/255~0)
Resetting the
System
Obey™ 40 User Manual Rev. 5 ML
This process will copy the physical fader assignment from one fixture into another.
1. Press <PROGRAM> and <TAP SYNC/DISPLAY>. This will enter the physical fader
assignment mode.
2. Press & hold the fixture button that contains the desired physical fader assignment.
3. While still holding the previous fixture button, press & hold the fixture that you want to copy
into.
4. While still holding the two fixture buttons above, press & hold <MIDI/ADD>.
5. While still holding all three buttons down, release the fixture selected in step # 2 above.
6. While still holding down <MIDI/ADD>, release the fixture selected in step # 3 above.
7. Release <MIDI/ADD>.
8. All fixture LEDs will flash.
9. Press <PROGRAM> and <TAP SYNC/DISPLAY> two times to exit physical fader
assignment mode.
This will not copy the fader-reverse setting(s).
This function will allow you to reverse the DMX output of the physical fader(s).
1. Press <PROGRAM> and <TAP SYNC/DISPLAY> two times. This will enter the fader
reverse assignment mode.
2. Select one of the fixtures: <FIXTURE 1~12> (this will be the fixture that you want to modify
the channels for).
3. Move the <SPEED> fader to select the physical slider (control channel).
4. Move the <FADE TIME> fader to activate/deactivate this function.
5. Press <MIDI/ADD> to save the setting.
6. Repeat steps 3~5 until all of the faders have been assigned for the fixture.
7. Press <PROGRAM> and <TAP SYNC/DISPLAY> one time to exit fader reverse
assignment mode.
Use this function to revert all settings and scenes back to the state they were in
when the product left the factory.
1. Turn off the unit.
2. Press and hold <BANK UP> and <AUTO/DEL>.
3. Turn on power to the unit (while still holding <BANK UP> and <AUTO/DEL>).
4. All LEDs will blink to indicate a successful reset.
This will erase all scenes, chases, and other settings! This process may take
up to 30 seconds to complete.
Page 11 of 44