Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Programming
Entering Program
Mode
Exiting Program
Mode
Creating a Scene
Create a Chase
Page 12 of 44
No programming may be done on the Obey™ 40 without first entering program
mode. You will find references to this process in many other sections of this user
manual. Press and hold PROGRAM for three seconds to exit program mode.
1.
Turn on the controller.
2.
Press and hold <PROGRAM> for three seconds.
3.
When the LED display Program LED lights, you have entered program mode.
You will find references to this process in many other sections of this user manual.
1.
While currently in program mode, press and hold <PROGRAM> for three seconds.
2.
When the LED display Program LED turns off, you have exited program mode.
Use this function to create a static look on stage.
1.
Turn on the controller.
2.
Enter program mode.
3.
Select one or more fixtures.
4.
Using the 8 sliders, modify the value of the desired channel(s).
5.
When the desired look has been achieved, press <MIDI/ADD>.
6.
Use <BANK UP/DOWN> to select a desired bank (30 possible) to save the scene to.
7.
Once you have navigated to the desired bank, press the <SCENE> (1~8) to save the
scene directly to.
8.
All LEDs will flash to indicate that the scene has been saved.
9.
Repeat steps 3~8 until you are finished programming all scenes.
10. Exit program mode.
You may select more than one fixture at a time. If you do so, you will not have
separate control over each of them. You may program multiple fixtures into the
same scene.
Use PAGE A/B to switch between the 2 pages for the selected fixture.
A chase is a series of scenes. Program the scenes before programming the chases.
1.
Enter program mode.
2.
Select the chase that will be programmed (1~6).
3.
Call up the first scene for the chase by pressing the appropriate <SCENE> button. You
may use <BANK UP/DOWN> to navigate through the different pages of the scenes.
4.
Once the controller is outputting the correct scene to the lights, press <MIDI/ADD>.
5.
All LEDs will flash when the scene is added to the chase.
6.
Call up the second scene for the chase by pressing the appropriate <SCENE> button.
7.
Once the controller is outputting the correct scene to the lights, press <MIDI/ADD>.
8.
All LEDs will flash when the scene is added to the chase.
9.
Continue through steps 6~8 until all of the scenes have been added to the chase.
10. Exit program mode.
Obey™ 40 User Manual Rev. 5 ML
Publicité
Table des Matières
