Honeywell Domonial Manuel D'utilisation page 7

DURESS CODE
E
A duress code can be used if you are forced to disarm your security system
N
under duress. Your duress code is +1 to your code (1234 => 1235, 6789 =>
6 7 8 0 ) .
G
The system will disarm as normal however a silent alert signal is transmitted
to your Alarm Receiving Centre .
L
I
WRONG CODE PROTECTION
S
If you enter 5 successive wrong codes, the keypad is blocked for 5 minutes.
H
SENDING A PANIC SIGNAL
You can send an instant panic alarm whenever you feel threatened whilst at home,
even when your system is not armed :
• Press the "SOS" keys simultaneously.
- The siren is triggered (depending on configuration).
- The Alarm Receiving Centre is alerted.
PROGRAMMING YOUR KEYPAD
The keypad can have up to 10 users. User 1 has the master code or master TAG.
• To enter programming :
- Press "on" and "off" control keys simultaneously.
The red light will flash slowly.
- Enter the master code or present the master TAG.
• To change or set additional user codes :
- Select and enter an existing or new single digit user ID (0-9).
- Enter the new code for this user.
A double beep on the keypad will confirm entry.
- Enter the new code again to confirm it.
A double beep on the keypad will confirm entry.
•To change or set additional key tags :
- Select and enter an existing or new single digit user ID (0-9)
(User 1 is always the master).
- Present the new key TAG.
A double beep on the keypad will confirm that the new TAG is
programmed and replace the previous TAG if any.
- 10 -
•To adjust beep level :
- Press the total set arming key
- Press the 8 key
Code + 1
- Enter beep level from 1 to 7
A double beep on the keypad will confirm the change
• To exit programming :
- Press the" off" control key
WARNING: The system will automatically exit programming mode after 15 seconds if no
keys have been pressed and the red light will turn off. If this occurs you must restart this
process from the beginning.
Total set arming
Part set arming
Annex set arming
Disarming
+
Disarming under duress
Alert
Enter programming
Change user code
Change user TAG
Change beep level
Exit programming
+ CODE or TAG
+ CODE or TAG
+ CODE or TAG
Enter CODE or present TAG
Enter DURESS CODE = CODE + 1
+ + MASTER CODE OR MASTER TAG
User ID 0-9 + enter new CODE
+ enter new CODE again
User ID 0-9 + present new TAG
+ + enter beep level 1-7
- 11 -
E
N
G
L
I
S
H