Installing Visor Mounted Microphone; Installing Push-To-Talk (Ptt) - Motorola WAVE Mobile TLK 150 Garantie Et Guide D'installation

4.4

Installing Visor Mounted Microphone

When and where to use:Visor Mounted microphone (Motorola Solutions part number GMMN4065_)
cable connects to a 16-pin MAP connector kit (Motorola Solutions part number HLN9457_).
Procedure:
1 Connect the lead of white lead wire with crimped contact to Pin 2 (Ext Mic Audio).
2 Connect the lead of ground wire with crimped contact to Pin 7.(Ground).
3 Connect Pin 6 (GPIO_3) to Pin 7 (Ground) for external microphone detection.
4 Plug the 16-pin MAP connector kit to the center of Rear Mobile Accessory Port (MAP)
Connector.
4.5

Installing Push-To-Talk (PTT)

When and where to use:Remote mount foot switch PTT (Motorola Solutions part number RLN4856_)
or remote mount push-button PTT (Motorola Solutions part number RLN4857_) cable connects to a
16-pin MAP connector kit (Motorola Solutions part number HLN9457_).
Procedure:
1 Connect the lead of wire with crimped contact to Pin 3 (GPIO-1).
2 Ground the lead of wire with crimped contact to Pin 7 (Ground).
3 Connect Pin 6 (GPIO_3) to Pin 7 (Ground) for external microphone detection.
4 Plug the 16-pin MAP connector kit to the center of Rear Mobile Accessory Port (MAP)
Connector.
MN006372A01-AF
Chapter 4 : Accessories Installation
31