NAD C740 Manuel D'installation page 9

STORING A STATION NAME
When a station is transmitting RDS information, your NAD C740
will automatically show the station initials when its Preset is used.
Although the receiver automatically shows the frequency of any
other AM or non-RDS Preset station, it also allows you to type in
the station name to make it easier to identify which station is
stored in the Memory Preset. To enter a name:
• Select the Preset you want to attach a name to.
• Then press Character (No. 18) and the first space in the Station
Data area of the Display Panel will flash.
• Press either the Tune/Preset
scroll and select the first character (see Character list for
reference).
• Pressing Memory (No. 15) will store the first character and
move forward to the next space on the line.
• Use the Tune/Preset buttons again to select the next character
in the name and press Memory to store it. Continue until the
station name is complete (up to 8 characters).
• Press Character again to store the completed name.
There are 54 characters available including a blank space.
_
A B C D
I J K L M
R S T U V
" & ' ( )
. / = ? [
1 2 3 4 5
NOTE: This function is only available for non-RDS stations. RDS
stations will always display their transmitted name and this cannot
be over-written using CHARACTER.
NOTE: The 120V versions (North America) do not have RDS
(Radio Data System)
REMOTE CONTROL HANDSET
The Remote Control handset handles all the key functions of the
NAD C740 and has additional controls to remotely operate NAD
Tuners, Cassette and CD machines. It will operate up to a distance
of 16ft (5m).
Alkaline batteries are recommended for maximum operating life.
Two AAA (R 03) batteries should be fitted in the battery
compartment at the rear of the Remote Control handset. When
replacing batteries, check that they have been put in the right way
round, as indicated on the base of the battery compartment.
Please refer to previous sections of the manual for a full
description of individual functions.
NOTE: The remote control handset supplied with the C740 is of a
universal NAD type, designed to operate several NAD models. The
Video 2 and Video 3 input selector buttons on the remote control
handset are inoperative in the case of the C740.
The Speaker A and B buttons, the Bank button, and input selector
buttons perform the same functions as the buttons labelled the
same on the front panel. There are a few differences and extra
functions with the remote control handset however:
or (No. 19) button to
E F G H
N O P Q
W X Y Z
+ , –
*
\ ] | 0
6 7 8 9
TUNER AM, TUNER FM
Pressing either the AM or FM button will select the tuner as the
active input and revert to the last station tuned to on respectively
the AM or FM band.
MUTE
Press the MUTE Button to temporarily switch off the sound to the
speakers and headphones. Mute mode is indicated by "AUDIO
MUTE" flashing in red in the display area. Press MUTE again to
restore sound. Mute does not affect recordings made using the
Tape outputs but will affect the signal going to the Pre-amp output
(Pre Out).
VOLUME
or respectively increases or decreases the Volume
setting. The motorised Volume Control on the front panel will
indicate the level set.
TUNER CONTROL
PRESET or allow direct selection of the desired preset.
Use of these buttons will automatically switch the tuner section to
Preset mode. Refer also to chapter "Front Panel Controls"; section
13 "Search/Preset" for more information.
Other than the commands relating to the NAD C740 receiver itself,
there are other buttons which will operate most NAD CD players
and Cassette decks equipped with NAD Link:
CD PLAYER CONTROL
(for use with NAD CD Player)
engages Pause
engages Stop
engages Play or toggles between Play and Pause
or engages Track skip; Press once to respectively go to
the next track or to return to start of current or previous track.
NEXT DISC Go to next disc (for NAD CD changers).
CASSETTE DECK CONTROL
(For use with single (DECK B) or double transport (A and B) NAD
Cassette Decks)
or engages Forward Play or Reverse Play.
Record / Pause. Press to put cassette deck into record-
pause. Press Play to start recording.
Stops Play or Recording.
engages Rewind.
engages Fast Forward.
NOTE: Direct sunlight or very bright ambient lighting may affect
the operating range and angle for the remote control handset.
NOTE: The infrared remote control command receiver, located
on the far left of the display window, receives commands from the
remote control. There must be a clear line-of-sight path from the
remote control to this window; if that path is obstructed, the
remote control may not work.
GB
9