Bosch PL2632 Consignes D'utilisation/De Sécurité page 15

2610052960.qxp_PL2632 7/17/19 8:53 AM Page 15
▶ Planer Stand
The planer stand automatically springs
down to help keep the blade from
coming in contact with the work surface
when planer is not in use (Fig. 12). The
planer stand is designed to swing up
and out of the way by it itself when the
back of the planer crosses the leading
edge of the workpiece (Fig. 10). It will
also swing up when planing begins in
the middle of the work piece (in from
the edge of the work piece).
▶ Beveling Edges
The V-groove in the front planer base
plate allow quick and easy beveling of
workpiece edges. (Fig. 13).
▶ Rabbeting
Although all of the compatible Bosch
planer guide fences can be used with
the PL2632 for rabbeting (sometimes
called "shiplapping"), the best fence for
this purpose is the optional dual-mount
fence.
The PL2632 can create rabbets up to 82
mm / 3-1/2" wide. (Fig. 14). Keep in
mind that it takes steady sideways
pressure and many passes to create
rabbets using a planer.
▶ Unclogging the Shavings
Exhaust System
becomes necessary to manually
remove shavings. The blades are hidden
from view and you may be cut if
contacted.
To minimize the possibility of clogging,
make sure:
1. The depth of cut is reasonable for the
material.
2. The feed rate is reasonable for the
material. (See DEPTH OF CUT AND
FEED RATE)
3. Unplug the planer and carefully insert
a screwdriver or similar object into
the exhaust port to break up the clog.
Operating Instructions
Remove plug from
power source if it
-15-
Fig. 14
9mm
max.