Eaton Cooper Lighting PORTFOLIO LSR6A Instructions D'installation page 2

Installation Instructions – LSR6A / LSSQ6A Commercial LED Rough-In
INSTALLATION
N otee: LED and Trim assembly to be installed only after
cylinder is installed.
Surface Mount Cylinder Bracket
1. Remove locking screw.
2. Rotate the mounting plate in anticlockwise direction to
separate from assembly and to remove from cylinder
(Figure 1.).
3. Attach mounting plate to Junction Box.
4. Attach tether under one Junction Box mounting screw
(Figure 3.).
5. Wire Unit per appropriate Wiring Diagram (refer to
electrical section). Push wiring into Junction Box.
6. Insert tabs from mounting plate in to cylinder top.
Rotate cylinder clockwise to engage hooks.
7 . Ensure holes are aligned, install Locking screw.
Trim
1. Remove lower trim from protective packaging. Remove
plastic and discard trim ring. Remove LED Engine from
protective packaging (Figure 4.).
2. Insert lens into lower trim with concave part facing
down (Figure 5.).
Figure 1.
LED Engine
Lens
Lower Trim
Figure 2.
2
Torsion
Springs
Plastic
Trim Rings
Installation Instructions – LSR6A / LSSQ6A Commercial LED Rough-In
705260INS ADP142624
Figure 3.
Figure 4.
Figure 5.
Align
Figure 6.
www.eaton.com
Mounting
Plate
Tether