Figure 3.4: Ldap Search Page In The Obwi - Avocent SwitchView IP 1020 Mode D'emploi

18 SwitchView IP 1020 Remote Access Device Installer/User Guide
example, to define an administrator Distinguished Name (DN) for test.view.com, type
, and
This Search DN field is a required
cn=Administrator, cn=Users, dc=test, dc=view dc=com.
field unless the directory service has been configured to enable anonymous search, which is not the
default. Each Search DN value must be separated by a comma.
The Search Password field is used to authenticate the administrator or user specified in the Search
DN field.
Use the Search Base field to define a starting point from which LDAP searches begin. The
modifiable default values are dc=yourDomainName and dc=com. For example, to define a search
base for test.com, type . Each Search Base value must be separated by a comma.
dc=test, dc=com
The UID Mask field specifies the search criteria for User ID searches of LDAP target devices. The
format should be in the form <name>=<%1>. The default value is sAMAccountName=%1, which
is correct for use with Active Directory. This field is required for LDAP searches.

Figure 3.4: LDAP Search Page in the OBWI