Connecting The Optional Power Adapter; Inserting The Tape Cassette - Dymo LabelManager 210D Guide D'utilisation

Connecting the Optional Power Adapter

An optional 9 Volt, 1.5 A power adapter can also be used to power the label maker.
Connecting the AC adapter to the label maker disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top, left side of the label maker.
2. Plug the other end of the power adapter into a power outlet.
x Make sure the label maker power is turned o before
you disconnect the power adapter from the main power
source. Otherwise, your most recent memory settings will
be lost.

Inserting the Tape Cassette

Your label maker comes with one tape cassette. You can
purchase additional tape cassettes from your local
office supply retailer.
To insert the tape cassette
1. Lift the tape cassette cover to open the tape
compartment. See Figure 3.
x Before using the label maker for
the first time, remove the protective
cardboard insert from the tape exit slot.
See Figure 4.
2. Insert the cassette with the label facing up
and positioned between the guideposts.
3. Press firmly until cassette clicks into place.
See Figure 5.
4. Close the tape cassette cover.
6
LM210D_manual_UK-WEU.indd 6
Figure 3
Guideposts
Remove
Figure 4
cardboard insert
Click!
Click!
Figure 5
28-06-2007 10:03:37