Samsung NY58J9850WS Manuel D'utilisation page 55

Masquer les pouces Voir aussi pour NY58J9850WS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Cause
Oven racks are
This is normal.
difficult to slide.
Fan noise.
This is normal.
Convection fan is
This is normal.
not working.
Warming drawer
Problem
Cause
Warming drawer
The controls are not set
will not work.
properly.
The Self-Clean or Sabbath
function is being used.
The oven controls have
been locked.
There is a blown fuse or
tripped circuit breaker.
Action
Apply a small amount of
vegetable oil to a paper towel
and wipe the edges of the
oven racks with the paper
towel. Racks become dull and
hard to slide if they are left in
the oven during a self-clean
cycle.
The convection fan runs until
the function is over or the
door is opened.
The fan starts automatically
when the oven reaches the
preheat temperature.
Action
Reset the controls as described
on page 40.
The warming drawer will not
operate when either of these
functions is operating. Try
again after these functions are
completed or cancelled.
Unlock the controls and try
again.
Replace blown fuse or reset
tripped circuit breaker.
Problem
Cause
Excessive
The temperature setting
condensation
is too high.
in the warming
The foods being warmed
drawer.
are not covered with a lid
or aluminum foil.
You are trying to warm
liquids.
Warming drawer
The drawer is not
or storage drawer
properly aligned with the
does not slide
full-extension roller guide
smoothly or drags.
rails or nylon drawer
guides.
The contents in the
drawer are too heavy.
Others
Problem
Cause
The product is not
The appliance has been
level.
installed improperly.
The leveling leg(s) is (are)
damaged or uneven.
The kitchen cabinets are
not properly aligned and
make the range appear to
be not level.
Action
See page 40.
Cover foods with a lid or
aluminum foil.
Liquid should not be warmed
in the drawer. Remove liquids.
Remove and replace the
drawer. (See page 49.)
Reduce the weight and/or
redistribute the contents in the
drawer.
Action
Make sure the floor is level,
strong, and stable. If the floor
sags or slopes, contact a
carpenter.
Check and level the range. (See
the Installation Instructions.)
Ensure that cabinets are
square and provide sufficient
room for installation.
English 55

Publicité

Table des Matières
loading

Table des Matières