Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm
soapy water. Then, scour soil off of the racks using a plastic scouring pad. If the
racks do not slide in and out smoothly after you have cleaned them, rub the side
rail guides with wax paper or a cloth containing a few drops of cooking oil. This
will help the racks glide more easily on their tracks.
NOTES
•
Do not use a dishwasher to clean the racks.
•
If a rack does not slide in and out smoothly, apply a few drops of cooking oil
to the oven rack guides.
•
If a rack becomes too difficult to slide in or out, lubricate the rack.
•
To purchase the graphite lubricant, contact us at 1-800-SAMSUNG (726-7864).
•
For online shopping, visit http://www.samsungparts.com/Default.aspx and
search for part DG81-01629A.
CAUTION
•
Do not leave the racks in the oven during the self-cleaning cycle. The extreme
heat generated in this cycle can permanently peel off the rack coating and
make it difficult to slide the racks on the guide rails.
•
Do not spray cooking oil or lubricant directly onto the gliding rack.
Door
Do not remove the inner gasket of the oven door for cleaning.
Inner side
•
Inner surface: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket
wet or allow moisture into the door.
•
Inner glass: The inner glass is cleaned automatically during the self-cleaning
cycle.
42 English
Outer side
•
Outer surface: Follow the cleaning instructions for the stainless steel surface in
the previous section.
•
Outer glass: Clean the outer glass using a glass cleanser or soapy water. Rinse
and dry thoroughly. Take care not to get the gasket wet or allow moisture into
the door.
*
Burner controls
Make sure all surface burner knobs are in the OFF position.
CAUTION
•
Do not clean the control knobs in a dish washer.
•
Do not spray cleansers directly onto the control panel. Moisture entering the
electric circuits may cause electric shock or product damage.
CAUTION
•
Do not let moisture enter the door or
contact the door gasket (*). Moisture
may reduce the gasket's performance.
1.
Pull knobs off the control valve stems.
2.
Clean the knobs in warm, soapy water.
Then, rinse and dry them thoroughly.
3.
Clean the stainless steel surfaces using
stainless steel cleaner.
4.
Re-attach the knobs to the control
valve stems.
Publicité
Chapitres
Table des Matières
Dépannage
