Samsung NY58J9850WS Manuel D'utilisation page 50

Maintenance
How to re-install the door
You can re-install the upper door the same way you re-install the full door.
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Bottom edge of slot
Hinge arm
Indentation
3. Open the door fully. If the door will not open fully, the indentation is not
inserted correctly in the bottom edge of the slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
Unlocked position
5. Close the oven door.
50 English
How to remove and re-install the warming drawer.
Warming drawer
Hinge lock
Locked position
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Using both hands, pull down the
left clip while lifting the right clip, and
then remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
To re-install, put the drawer in the
4.
roller guides on either side, and then
snap the clips into place.