Expert Mode - Philips Cineos 42PF9830A/37 Mode D'emploi

2496.1 16x24 en 14-12-2005

Expert mode

When you do not want the remote to go back to TV mode, and to stay in the mode selected, proceed as
follows:
&
Select TV mode with the
é Press the
SELECT
"
Select the desired mode with the
The remote will not go back to TV mode from now on and will remain in the mode selected.To go back
to the default setting of the remote (TV mode) repeat what is explained above, selecting the TV mode.
Note: LED behavior
- If the LED blinks once
seconds, the remote control is in
- If the LED blinks
4 times
remote control is in
Direct selection of a connected device
When the remote is in
Press the button:
AV+
- followed by digit '
- followed by digit '
- followed by digit '
- followed by digit '
- followed by digit '
- followed by digit '
Note: Make sure your device is turned on.
10:11 Pagina 63
button.
SELECT
button again simultaneously with the
SELECT
after pressing the
SELECT
Expert mode and the remote control remains in the mode selected.
after pressing the
SELECT
and the remote control returns to TV mode after 60 seconds.
Normal mode
TV Expert mode you may directly select a connected device in the following way:
' to select the device connected to
1
' to select the device connected to
2
' to select the device connected to
3
' to select the device connected to
4
' to select the device connected to
5
0 ' to select the device connected to the side.
button for at least 2 seconds.
OK
button.
button simultaneously with the
button with the button for at least 2 seconds, the
OK
.
AV1
.
AV2
.
AV3
.
HDMI1
.
HDMI2
button for at least 2
OK
63