Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
4
Set the adapter speed tye ‚NIC type'
If you wish the address data to
be automatically assigned, tick
manually. Default and recommended
the "Enable DHCP" checkbox. The
setting is the automatic detection
(Self adaptive).
addresses will then be automatically
assigned by your router (where
supported).If proceeding in this way,
move on to point 11.
34
6
192.168.0.20
192.168.0.25
192.168.0.1
If your router does not automatically
assign the address data, enter the
data according to the following steps.
The image gives an example of con-
nected devices with the correspon-
ding IP addresses.
English
7
8
The fi rst three positions of the IP
The subnet mask is a network
address must correspond to the
segment in which IP addresses with
default gateway value. The fi nal digit
the same network address are used.
identifi es devices addressed by the
The standard value is normally
default gateway and is individually
255.255.255.0 in such cases. To
set for each device. For the recorder,
determine the value for the default
choose e.g. 64: i.e. xxx.xxx.xxx.64.
gateway, use a Windows PC connected
to the network.
English
9
Enter the IP address of your router
here. You can fi nd the address with
"cmd" and the command "ipconfig"
on your Windows PC.
35
Publicité
Table des Matières
