1000 Satellite - HK Audio L.U.C.A.S 1000 Mode D'emploi

cool. Always keep the fan and the ventilation slots
free of dust and debris to ensure that cool air can
circulate freely. Heat can kill electronics!
9 Circuit Breaker
This automatic circuit breaker serves the same
purpose as a standard fuse. If it trips, you can reset
the circuit breaker by simply pressing it - after you
have identified and taken care of the problem.
Caution: Always switch the system off before you
reset it. (Power switch in the Off position!)
10 Power Switch
On/off switch for the active system. This red rocker
switch will illuminate as an indication that the unit
is powered up. Additionally, the red LED in the upper
control panel lights up when the system is switched on.
11 Mains Input
Use the factory-included power cord to connect this
socket to a wall receptacle.
Caution: Make sure the local mains voltage matches
the voltage specified on the device. If you connect
the system to the wrong mains voltage, you may
destroy the electronic components of the system.
12 Satellite Left and Satellite Right
Connect the Speakon ® outputs to the left and right
L.U.C.A.S ® 1000 satellites.
13 Mains Cable Tab
Clamp the power cable under the tab to prevent it
from being pulled out inadvertently.
1
3
3.2 L.U.C.A.S ®

1000 Satellite

Speaker Input
Speakon ® NL 4 socket (pin 1+ = +, pin 1- = -).
To establish an electrical connection, plug in the
Speakon ® connector and then rotate it to the right
until it engages. Before you can unplug it, you will
first need to disengage the safety catch. To accom-
plish this, pull the bayonet catch towards the cable.
1 1
3 4
6
9
12
2
5
7 6 7
8
8
10
11 12
14
7