Technical Support Service; Emergencies - Enofrigo DOGE ISOLA Notice D'instruction

The lighting or
ventilation do not
work..
The displayed
temperature is not in
conformity with the
real one.
The thermoregulator
does not work
correctly.
The hood is blocked
or difficult to move
(in models with
opening hood)
ATTENTION:
Gurgling and blowing noises caused by the refrigeration circuit are normal.

TECHNICAL SUPPORT SERVICE

You are advised to contact the manufacturer or authorised dealer who will carry out any overhauling and repair
work via specialist personnel using purposely designed equipment.
The data given in the identification plate (see chapter 5) must always be communicated to the technical
support service, in particular:
The type of fault;

The machine model;

The machine serial number;

Your address;

Your telephone number.


17.EMERGENCIES

Correct use of the machine ensures that emergency situations cannot occur during operation, cleaning and
maintenance provided that the instructions given in this manual are followed.
30
The power supplì cable is damaged or
interrupted.
The mains bipolar switch is off.
Power failure on controls.
The light or ventilations witch is off.
Light is damaged or interrupted.
The probe is not properly set.
The set values are not correct.
The superstructure supporting system is
damaged
The steel cords supporting the upper part
are damaged
CT68900001_
Check the condition of the.
compressor. If necessari contact a
qualified technician to replace it with
another one of the same type.
Turn the mains bipolar switch on.
Check the condition of the controls If
necessary,contact a qualified technician
to restore the current.
Turn the light or ventilations witch on.
Check the condition of the.
lighting. If necessari contact a qualified
technician to replace it with another one
of the same type.
empty the water from the tank
Reset the thermoregulator.
Check the condition of the system. If
necessary contact the manufacturer or
authorised dealer for replacement
Check the
running of the cords. If necessary,
contact the manufacturer or authorised
dealer for replacement
Rev.00 07/13
condition and smooth