Faults And Possible Solutions - Enofrigo DOGE ISOLA Notice D'instruction

Once a day
Check that the power supply cable is in perfect condition; if not replace it with another one of the same

type.

16.FAULTS AND POSSIBLE SOLUTIONS

For troubleshooting and related repairs, refer to the table below.
FAULT
The refrigeration
system does
Not start.
The machine
temperature is
Not colde nough.
The machine
temperature is too
cold.
Ice on the innner
backside
Water on the bottom
of the machine.
29
POSSIBLE CAUSE
Themachine is un plugged.
From the current socket.
The power supplì cable is damaged or
interrupted.
The mains bipolar switch is off.
Power failure on controls.
There is a current interruption on the
controls.
The compressor does not work.
The thermoregulator is not correctly set.
The machine is installed near a heat
source.
The machine ispositione dless than 15cm
away from surrounding obstacles.
The air circulation via the ventilation
apertures is obstructed.
There is an interruption in the refrigeration
circuitor there is no gas.
The thermoregulat or is not set to the
correct position.
The door has been kept open for a long
time or the inside temperature is too low.
The defrosting water outlet is clogged.
The machine is not plugged into the
current socket.
CT68900001_
POSSIBLE SOLUTION
Plug in correctly.
Check the condition of the cable.If
necessary contact a qualified technician
to replace it with another one of the
same type.
Turn the mains bipolar switch on.
Check the condition of the controls If
necessary,contact a qualified technician
to restore the current.
Ad just the thermoregulator as come
shown in chapter n°13.
Check the condition of the.
compressor. If necessari contact a
qualified technician to replace it with
another one of the same type.
Ad just the thermoregulator as come
shown in chapter n°13.
Move the machine a way from the heat
source as described in chapter n°12.
Move the machine away from the
surrounding
Chapter12.
Free the ventilation apertures.
Contact a qualified technician to check
that the gas expansion temperature.
Ad just the thermoregulator as come
shown in chapter n°13.
. Check the hermetic lock of the door.
Increase automatic
manual defrosting.
Set thermoregulator as indicated in
chapter 13.
Check that there are no impurities on
the drainer.
Plug the machine in correctly.
Rev.00 07/13
obstacles,as shown
defrosting. Set
in