Service And Repair; Troubleshooting - RIDGID CT400 Manuel De L'opérateur

CT400 Press Tool

Service and Repair

Service and repair on this CT400 Press
WARNING
Tool must be performed by a RIDGID Authorized Service
Center. The tool fasteners have been marked to indi-
cate if service has been performed by unauthorized
individuals. Improper service or repair may lead to exten-
sive property damage, serious injury or death.
For any repairs or maintenance, contact the Ridge Tool
Company, Technical Service Department at (800) 519-
3456 or www.ridgid.com for nearest authorized service
center.

Troubleshooting

SYMPTOM
Tool beeps after a press-
ing cycle is completed.
Tool will not run when
switch is depressed.
The pressed connections
produced are not
complete.
POSSIBLE REASONS
Scheduled maintenance/recalibration required.
Tool is not plugged into an electrical outlet.
Jaw set mounting pin is not properly engaged.
The electrical cord is damaged.
Scheduled maintenance/recalibration is required.
Used wrong jaw set for the tube size or material.
The tool was not square to the tube.
Jaw contour was not aligned with the fitting contour.
Tool is in need of repair.
Ridge Tool Company
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
Contact Ridge Tool Company, Technical Service
Department at (800) 519-3456 for nearest autho-
rized service center.
Plug tool into an electrical outlet.
Push the mounting pin until it is fully inserted.
Inspect the electrical cord and replace if necessary.
The tool will beep when it is time for the scheduled
maintenance/recalibration. If it is not serviced after
2,000 more cycles, it will not run until the mainte-
nance/recalibration is performed.
Install the correct jaw set.
Redo the joint using new tube and fitting and make
sure that the tool is square to the tube.
Redo the joint using new tube and fitting and make
sure that the tool is square to the tube.
Contact Ridge Tool Company, Technical Service
Department at (800) 519-3456 for nearest autho-
rized service center.
SOLUTION
9