Astrapool BASIC 37058 Manuel D'installation page 34

Un système de détection d'immersion
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TEST VALIDATION SHEET
To be filled out in block letters and imperatively sent back by mail
serial number:
Owner
Mr. Mrs. Miss First name:
Address:
Postcode:
Country:
E-mail :
Tel. :
Date of purchase:
Retailer
Retailer name:
Address:
Postcode:
Country:
E-mail :
Remarks:
Your immersion detector has been designed and configured to detect a child (of minimum weight 6 kg) falling into a swimming pool with maximum
dimensions of 10 m x 5 m. You must imperatively perform these validation tests after final setting up of your immersion detector, by scrupulously
following the recommendations given in the installation and operation guide. In case of malfunction, please refer to the recommendations written on the
packaging, or contact your retailer. Make sure that the pool is still, that there is no wind, and that your immersion detector is monitoring (green indicator
light flashing). If such is not the case, move the magnet over the swimmer symbol. If in spite of this, the indicator light does not switch to green, the pool
is not still enough. You must imperatively wait until your pool is still before carrying out the tests.
Test 1 - Filtering
Filtering system running for 10 minutes, your immersion
detector is monitoring (green indicator light flashing),
and must not either stop (red indicator light flashing)
or go off.
Basic
: 37058/PRE007-A
TM
FILL IN and SEND this test validation sheet by mail to AstraPool within 7 DAYS
AFTER THE PURCHASE of your immersion detector.
This sheet must be initialed on both sides, and bear the handwritten statement
"tests successful, performed as per recommendations" followed by your signature
(see overleaf). The 2-year contractual guarantee is conditioned by the dispatch of
the test validation sheet. In case of negligence or non receipt of the test validation
sheet, AstraPool will accept no responsibility for proper operation. The purpose of
these tests is to validate the proper operation of your device, and to ensure
optimal fall detection according to the pool configuration.
Surname:
Town:
Tests performed on:
Town:
if OK
Test 1 validated by the owner*:
Test 1 validated by the installer*:
Signature of present owner:
*cross out inappropriate statement (presence of installation engineer is not obligatory but is
recommended)
Yes
No
Yes
No

Publicité

Table des Matières
loading

Produits Connexes pour Astrapool BASIC 37058

Table des Matières