Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
Place and keep one of the magnets on the swimmer symbol until the loud beep is heard, and until
the red indicator light flashes quickly, then move the 2nd magnet over the red Stop symbol. The
red indicator light remains on during the confirmation sound signal (15 short beeps).
Warning: When you place the magnet on the swimmer symbol, the device responds at first
as described in sections 4.1 "I want to have a swim" and 4.3 "Manual restart". You must keep
the magnet on this area to hear the loud beep and fast flashing of the red indicator light.
To reactivate your immersion detector:
I
Move the magnet over the swimmer symbol;
You will hear 5 short, high-pitched beeps + flashing red indicator light.
I
I
Wait for the automatic restart (flashing green indicator light) or restart manually (see item 4.3)
Please make sure that your immersion detector is in armed mode before leaving your
pool.
If such is not the case, utmost vigilance is required from the parent/responsible adult.
4.7. Replacing the batteries
Your immersion detector gives a low-battery alert by:
I
1 short, low-pitched beep every minute,
4 short, low-pitched beeps every time the magnet is moved over the swimmer symbol.
I
In this case, the four 1.5V LR20 alkaline batteries must be replaced with new batteries of the same
type as soon as possible.
The use-by dates are given on the alkaline batteries. Be responsible, and take the old batteries back
to your retailer instead of throwing them away.
We advise you not to change the batteries at the start of the season.
When replacing the batteries, please follow the indications below:
Put your immersion detector in off mode (see item 4.6)
1
When putting your immersion detector in off mode, please take all necessary steps to secure access
to your pool.
DURING THIS TIME, YOUR POOL IS NOT PROTECTED. UTMOST VIGILANCE IS
REQUIRED FROM THE PARENT/RESPONSIBLE ADULT.
2
x15
22
Publicité
Table des Matières
