Safety Regulations For Bathrooms - RIHO Olivia Mode D'emploi

1.0 Installation of RIHO Whirlpools
The Whirlpool baths are fully in conformity with the applicable EN and national guidelines.
NOTICE:
The installation of the bathtub must be carried out by an appropriately certified worker.
=
The installation of the bathtub must be carried out in accordance with the assembly instructions given in these
=
instructions and drawings for the bath, where its dimensions are stated; The position of the supports and
fasteners is unique for each bathtub and must be found on the bathtub supplied.
The customer is responsible for the proper preparation of construction, wiring and plumbing work.
=
Use of cleaning materials other than those recommended by the manufacturer may result in damage to the tub
=
and / or whirlpool system.
Testing and restoring current protectors must be performed regularly.
=
This appliance may be used by children under 8 years of age and older and persons with reduced physical,
=
sensory or mental capabilities or lack of experience and knowledge if supervised or instructed to use the
appliance in a safe manner and understand the potential hazards.
Children can not play with the appliance.
=
Cleaning and maintenance carried out by the user must not be carried out by children without supervision.
=
The maximum allowable altitude for the use of the device is 2000 m. M.
=
If the power supply is damaged and if there is any malfunction (eg nozzle, engine, light humidity, etc.) the
=
bathtub must be turned off and contact the RIHO service department.
Parts containing live parts, except for parts powered by a safe low voltage not exceeding 12 V, shall not be
=
available to the person in the bath.
Parts containing electrical components other than remote control devices must be located or fixed in such a
=
way that they can not fall into the bath.
The whirlpool bathtub must only be adjusted by installers who can demonstrate to the competent authorities
knowledge and skills to meet national safety requirements, ie water intake / drainage and power supply.
Before first use, the following test shall be carried out:
After installation, check if the bathtub is clean. The bath is filled with water at an inlet temperature of 40 +/- 5 ° C to
the level above the highest nozzle that allows the system to operate. Turn on the system and let it run for at least 10
minutes. Test the aero motor by using all 5 levels at least once during the test. Without draining, the whirlpool system shuts
off 30 minutes after the last button has been touched. Check all pipelines, connections for leakage of water.
After all necessary adjustments to ensure the integrity or replacement of any defective elements, the procedure is
repeated.
The installer and the first whirlpool owner must provide instructions for use and maintenance to other owners and users.
1.1

Safety regulations for bathrooms.

Electrical sockets, lamps, switches and/or other electrical equipment should be
installed outside the danger zones indicated in the national guidelines and standards.
Above all, the regulations prohibit the presence of any electrical installation within 60
cm around the bath, and less than 225 cm above it (see Fig.1). The switch and other
electrical devices should be installed so as to be inaccessible to the person using the
whirlpool.
THE MANUFACTURER REFUSES TO ACCEPT ANY LIABILITY IN THE FOLLOWING CASES:
Legal requirements or provisions for earthing, protective and electrical installation in the bathroom have not
=
been met
The applicable laws and standards for bathrooms have not been complied with
=
The instructions in this manual have not been followed.
=
Parts are dismantled after inspection in the factory to facilitate transport and to enable it to be carried into the room in which
it is to be installed. It is advisable to check all the components of the bath before installation.
Any damage claimed after installation will not be covered under the guarantee.
IW00290.1
Fig. 1 Safety distances.
-2-
6 0
c m
2 4
0 c
m