Basic Functions - RIHO Olivia Mode D'emploi

Whirlpool TLCD - Manual
EN
In addition to the programming mode the other part of the display gives information on the status of your system. See
example below. You will see the icon turn white when the function is active. This applies to multiple keys.

4.1 Basic Functions

Before starting the Whirlpool bath, fill the bath to 5 cm above the highest jet (hydro-system) and about 15 cm below the rim
when you have only an aero system. The bath indication will then show full.
Important:
As a protection, the system will switch off automatically after 20 minutes, unless the system is switched off manually in
advance.
Bath is filled sufficiently
Bath is filled insufficient
There are 2 possibilities to operate your bath.
- Use personal setting (see 4.2).
- Use control unit by hand. You can touch the buttons on the screen to choose which function you want to put on or off.
You can easily switch off complete system with the (emergency) stop button.
Hydro active
-11-
Hydro inactive