Riho Acrylic Baths (Whirlpools); Maintenance - RIHO Olivia Mode D'emploi

Whirlpool TLCD - Manual
EN
2.0 Riho Acrylic (PMMA) baths (Whirlpools)
All Riho baths are made of acrylic (polymethyl methacrylic) and supported in the bottom with chipboard and reinforced
with glass fibre polyester.
Acrylic is a plastic and coloured all the way through.
The properties of acrylic provide the user with the maximum bathing comfort, provided the appropriate installation and
maintenance instructions are duly followed.
3.0

Maintenance

Thanks to the non-porous, smooth surface of the material, dirt will not or will hardly stick to the material. Maintenance
=
can be limited by cleaning the bath after use with a wet sponge or cloth and a liquid cleaner (without abrasive material).
The repair of small cracks and similar damage to the bath.
=
If you want to repair minor damage, due care is recommended. You may proceed as follows:
If there are fine scratches, it will be adequate to use a chrome and lacquer polisher (solvent and abrasive free). If the
=
result of this is not satisfactory, you may sand off the damage with waterproof sandpaper no. 600 and then with
waterproof sandpaper no.1000. Reprocess with a chrome and lacquer polisher for a perfect end-result and your bath
will be as good as new.
A complete set may be obtained from RIHO (Article no.:
=
WARNING:
You may repair your bath yourself at your own risk!
Major damage, deep scratches, holes and even cracks may be repaired and can almost be made to disappear. It is
recommended that these should be repaired by specialised technicians.
REP400 ).
-9-