Philips Satinelle Ice HP6491 Instructions page 12

ENGLISH
12
Problem
Skin irritation
occurs.
The skin
cooler is not
cold enough.
The pivoting
cooling head
of the skin
cooler doesn't
move.
The epilating
head cannot
be removed.
Cause
You used the epilator for the
first time or after a long
period of disuse.
The skin cooler was not
frozen long enough.
The skin cooler was not put in
the freezer or freezing
compartment.
The skin cooler does not
touch the skin.
The pivoting cooling head is
frozen.
You are not moving the
epilating head in the right
direction.
Solution
Some skin irritation may occur
the first few times you use the
appliance.This is absolutely
normal and should quickly
disappear. For tips to reduce
skin irritation, see the first
section of chapter 'Using the
appliance'. Also make sure you
keep the epilating head clean.
Put the skin cooler without the
insulating sleeve in the freezer
or freezing compartment (***)
for at least 4 hours.When the
colour of the fluid has changed
from white to completely blue,
the skin cooler is ready for use.
Put the skin cooler without
the insulating sleeve in the
freezer or freezing
compartment (***) for at
least 4 hours. Do not store
the skin cooler in the
refrigerator.
Make sure the skin cooler is
always in proper contact with
your skin during epilation.
Pass the skin cooler over your
leg a few times to make it
start pivoting again. Always
make sure the outside of the
skin cooler is completely dry
before you freeze it.
Press the release button and
move the epilating head in the
direction of the arrow (fig. 7)
to remove it.