Taski diversey swingo 755B Power Manuel D'instructions page 14

Blade change swingo 955B/1255B
Blade in the inner radius
I
I1
X < Y
X
Y
• Put the clean squeegee body with the rolls downward on a
solid surface (table, ground, etc.). (Detail I1)
• Loosen the screw (do not remove it completely) in the mid-
dle of the 2 parts of the tightening strap until the tightening
strap can be removed. (Detail I2)
• Clean squeegee body, blades and tightening strap under
running water with a brush.
• Mount the "turned" or new blade onto the squeegee body.
• Put the tightening strap in the right position on the blade
(Detail I3).
• Tension the tightening strap. (Detail I2)
Blade on the outer radius
A
A2
A1
X < Y
X
Y
• Put the clean squeegee body with the rolls downward on a
solid surface (table, ground, etc.). (Detail A1)
• Loosen the screws (do not remove them completely) on the
left and right side of the 3-part tightening strap until the
tightening strap can be removed. (Detail A2)
• Clean squeegee body, blades and tightening strap under
running water with a brush.
• Mount the "turned" or new blade onto the squeegee body.
• Put the tightening strap in the right position on the blade
(Detail A3).
• Tension the tightening strap. (Detail A2)
I2
I3
I1
A3
A2
A1
13