Taski diversey swingo 755B Power Manuel D'instructions page 12

Removing and cleaning the suction nozzle
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
Empty and clean the recovery tank and fresh
water tank
Notice:
Drain water or cleaning solution must be disposed
of in compliance with the national regulations.
Notice:
When draining the recovery tank, the regulations of
the detergent supplier regarding personal protec-
tive equipment of the cleaning solution manufactur-
er must be observed.
Proceed as follows:
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
Cleaning the recovery tank and fresh water tank
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough-
ly with clean water.
• Remove the dirt sieve (yellow), emp-
ty it and thoroughly rinse it under run-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
Caution:
Clogged suction filters may impair the suction per-
formance.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
Cleaning the fresh water tank filter
Caution:
Clean the fresh water tank filter after the end of op-
eration.
Clogged filters can inhibit the supply of detergents and
thus lead to surface damage.
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
Notice:
The filter is lower than the drain hole of the tank. A
rest amount of cleaning solution will run out only
when the filter is removed.
• Put the filter back and twist it closed.
Removing and cleaning the brush
Notice:
Clean the brush whenever cleaning work is com-
pleted.
• The machine must be switched off.
Variant: 955B / 1255B
• Push the tool ejector briefly but firmly
with your foot.
• Rotate the tool counterclockwise
away from the tool connection using
your foot.
• Remove the brushes and clean them under running water.
11