Electrical Connection - Baumer CombiTemp TCR6 Instructions

Masquer les pouces Voir aussi pour CombiTemp TCR6:

Mode d'emploi (15 pages)

Table des Matières

Les langues disponibles

English

Mounting

The CombiTemp™ TCR6 can be mounted in more different ways.

Sensor tube without connection

Baumer offers compression glands fitting Ø6 and Ø8 mm sensor diameter.

This type of mounting is normally used for mounting a sensor direct into a non-pressurized application. If pressurized, ensure that the

connection is tightened correct, so no leakage occur.

A duct channel mounting flange for 8 mm sensor is also available

All threaded connection can be mounted direct into the application without thermowell, however often a thermowell is required to enable the user

to take out the sensor for e.g. calibration without opening the system.

Sensor with male threaded process connection G½A

This G½A connection can be mounted in a Baumer thermowell type 8139 or ZPT4.

The process connection available are R½, G½, G¾, M20

or with hygienic ISO 2852 clamp DN 38

Sensor with male threaded process connection G¾A and G1A and sensors with G½ or G¾ female thread

For these connections a special thermowell can be supplied.

Mount the gland/pocket into the application and install the sensor after the gland/pocket is fixed to the application. This will ensure that the cable is

not twisted during mounting.

Baumer recommend to use a thermal compound filled into the thermowell ensure best possible heat transfer between the pocket and the Com-

biTemp TCR6.

Baumer offers a 6 gram bag Thermal compound, type ZPX1-001.