Installation/Connection - Kenwood DPX794BH Mode D'emploi

Learning Steering Remote Control
7
Press and hold any control keys on your steering remote control
which you want to assign.
A list of key functions will appear on the display.
[NONE] (default)/[ATT]/[SEEK UP]/[SEEK DOWN]/[VOL UP]/[VOL DOWN]/[MODE]/
[ON HOOK]/[OFF HOOK]/[VOICE]/[ENTER]
8
Turn the volume knob to select a function to assign, then press the
knob.
The selected key function is assigned to the steering remote control key
you have selected in step 7.
The display returns to the key list as on step 5.
• [K## (Function)]: When certain function has been assigned to a key.
9
Repeat step 6 to step 8 to assign other control keys.
10
Press and hold to exit.
Reassign the control keys
1 Press B SRC repeatedly to enter STANDBY.
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [SYSTEM], then press the knob.
4
Turn the volume knob to select [USER S.REMO], then press the knob.
5
Turn the volume knob to select [RESET KEY], then press the knob.
6
Turn the volume knob to select [YES], then press the knob.
All the control keys will be reset.
Selecting [NO] will cancel the operation.
When [FACTORY RESET] is set to [YES] (page 7), it will also reset the learning
steering remote control.
To return to the previous setting item, press

Installation/Connection

(for )
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car
• To prevent short circuit:
• Install this unit in the console of your vehicle. Do not touch the metal parts
• Do not connect the
• Mount the unit at an angle of less than 30°.
• If your vehicle wiring harness does not have the ignition terminal, connect
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers,
.
• If the fuse blows, first make sure the wires are not touching car's chassis,
This section is for the professional installer.
For safety's sake, leave wiring and mounting to professionals. Consult the
car audio dealer.
WARNING
chassis or Ground wire (black) to prevent a short circuit.
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires
that comes into contact with metal parts to protect the wires.
CAUTION
of this unit during and shortly after use of the unit. Metal parts such as the
heat sink and enclosure become hot.
wires of speakers to the car chassis or Ground wire
(black), or connect them in parallel.
Ignition wire (red) to the terminal on the vehicle's fuse box which provides
12 V DC power supply and is turned on and off by the ignition key.
etc. on the car are working properly.
then replace the old fuse with one that has the same rating.
35
ENGLISH