Setting The Color System - Pioneer PDA-5003 Mode D'emploi

Other Operations

Setting the COLOR SYSTEM

INPUT3 and INPUT4 are compatible with a number of TV
system formats used around the world, which are
automatically detected by this unit.
Normally [COLOR SYSTEM: AUTO] should be selected
for automatic detection. However, some video signals are
dubbed over or in certain conditions may not be displayed
properly (loss of color, etc.) by this setting. In this case,
change the setting according to the input signal.
Note
Setting the TV system format is required for each input (INPUT3
and INPUT4). Setting assignment and exclusive use according to
the TV system format of your input signal will enable prompt
processing of signals and reduction of time for input selection
and possible errors in detecting signals.
MENU
5/∞
2/3
SET
Display operating panel
1
Press the MENU button to display the menu
screen.
MENU
PICTURE SCREEN
:
CONTRAST
:
BRIGHTNESS
:
COLOR
:
TINT
:
SHARPNESS
PICTURE RESET
SET ENTER
40
En
MENU
2/3
SET
5/∞
Remote control unit
INPUT3
SETUP OPTION
0
0
0
0
0
MENU EXIT
2
Use the 2/3 buttons to select [SETUP].
MENU
PICTURE SCREEN
AUTO POWER OFF
COLOR TEMP.
DNR
MPEG NR
CTI
PURECINEMA
COLOR SYSTEM
CHANGE
SET
3 Use the 5/∞ buttons to select [COLOR SYSTEM].
MENU
PICTURE SCREEN
AUTO POWER OFF
COLOR TEMP.
DNR
MPEG NR
CTI
PURECINEMA
COLOR SYSTEM
SET ENTER
4
Press the SET button repeatedly until the
appropriate setting appears.
The factory default setting is [AUTO].
Each time SET button is pressed, the settings change
in the following order:
3 AUTO 3 NTSC
PAL N 2 PAL M 2
MENU
PICTURE SCREEN
AUTO POWER OFF
COLOR TEMP.
DNR
MPEG NR
CTI
PURECINEMA
COLOR SYSTEM
SET ENTER
5
When the setup is finished, press the MENU
button to exit the menu screen.
INPUT3
SETUP OPTION
:
DISABLE
:
MIDDLE
:
MIDDLE
:
LOW
:
ON
:
OFF
:
AUTO
EXIT
MENU
INPUT3
SETUP OPTION
:
DISABLE
:
MIDDLE
:
MIDDLE
:
LOW
:
ON
:
OFF
:
AUTO
MENU EXIT
3 PAL 3 SECAM
4.43 NTSC 2
INPUT3
SETUP OPTION
:
DISABLE
: MIDDLE
:
MIDDLE
:
LOW
:
ON
:
OFF
:
NTSC
MENU EXIT