Part Names And Functions; Connection Panel - Pioneer PDA-5003 Mode D'emploi

Part Names and Functions

Connection panel

Illustration depicts PDP-505CMX/PDP-504CMX/
PDP-50MXE10/PDP-50MXE11/PDP-50MXE1/
PDP-50MXE1-S model.
When installing PDA-5003
S-VIDEO
~
When installing PDA-5004
S-VIDEO
^
SPEAKER
R
8Ω ~16Ω
+ –
1
Plasma Display Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals.
When this video card is installed on a plasma display, an
additional three sets of video input connectors are provided
(total five), together with one additional video output
connector (total two). See the pages noted in parentheses
( ) or the plasma display's Operating Instructions for details
regarding connections to the various jacks and connectors.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2
COMBINATION IN/OUT
Never connect any component to these
connectors without first consulting your Pioneer
installation technician.
These connectors are used for plasma display setup
adjustments.
3
RS-232C
Never connect any component to this connector
without first consulting your Pioneer installation
technician.
This connector is used for plasma display setup
adjustments.
4
En
INPUT3 INPUT4 AUDIO
VIDEO INPUT 3/4
IN OUT R L G(ON SYNC) B
! @ #
INPUT3 INPUT4
AUDIO VIDEO
R L IN OUT R L
& * ( )
IN OUT
RS-232C
COMBINATION
2 3
POWER AC IN
OFF ON
0 -
INPUT5
ANALOG RGB AUDIO
R HD (H/V SYNC) VD R L
$ %
COMPONENT
INPUT5
AUDIO AUDIO
VIDEO
Y Pb/Cb Pr/Cr R L
_ +
ANALOG RGB IN ANALOG RGB OUT
D-Sub
4
4
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or external
RGB decoder; or components equipped with
component output jacks, such as a DVD recorder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 7 to 10).
5
ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use the ANALOG RGB OUT (INPUT1) connector to
output the video signal to an external monitor or other
component.
Note: The video signal will not be output from the ANALOG
RGB OUT (INPUT1) connector when the main power of this
display is off or in standby mode (page 10).
6
AUDIO (INPUT1) (Stereo mini jack)
Use to obtain sound when INPUT1 is selected. Connect
this jack to the audio output connector of the device
connected to the plasma display's INPUT1 (page 15).
7
DIGITAL RGB (INPUT2) (DVI-D jack)
Use to connect to a computer. With the PDP-
505CMX/PDP-50MXE10/PDP-50MXE11, it can also be
used to connect to an AV component (HDCP-
compliant) equipped with DVI output.
SPEAKER L
8Ω ~16Ω
+ –
=
INPUT1 INPUT2 OUTPUT
D-Sub
AUDIO DIGITAL RGB AUDIO AUDIO
DVI-D
5 6 7 8 9