Energy Saving Settings (Energy Save) - Pioneer PDA-5003 Mode D'emploi

Other Operations
Under factory default settings, the screen display
contents will change as follows:
Inverse White mask
Set
image* display
[ONCE]
[TIME TO
10 minutes 30 minutes
ACTIVATE]
(set in step 7).
Inverse White mask
Set
image* display
[REPEAT]
[TIME TO
10 minutes 30 minutes
ACTIVATE]
24 hours
(set in step 7).
This cycle repeats
* The color and brightness of the current image are displayed in
inverse values. The respective RGB color output levels are
inverted, with light areas appearing dark, and dark areas
appearing light.
Notes
÷ When set to [ONCE], after the screen management program
ends, this part of the display will change to the [OFF]
message. If you wish to continue the screen management
program, use the 2/3 buttons to select [ONCE] again, or
change to [REPEAT].
÷ During screen management operation when set to [ONCE] or
[REPEAT], if the display's MAIN POWER switch is turned OFF,
the screen management program will end, and this part of the
display will change to display the message [OFF]. If you wish
to continue the screen management program, use the 2/3
buttons to select [ONCE] or [REPEAT] again.
6 Use the 5/∞ buttons to select [TIME TO ACTIVATE].
SCREEN MGT.
STATUS
TIME TO ACTIVATE
START
RETURN
SET
7 Use the 2/3 buttons to set the time you wish the
screen management program to begin.
When the 2/3 buttons are pressed, the screen
management operation can be set from 0 to 24 hours,
in 10-minute units.
8 Use the 5/∞ buttons to select [START].
SCREEN MGT.
STATUS
TIME TO ACTIVATE
START
SET
SET
9
Press the SET button.
The set value will be stored in memory, and the screen
will return to that shown in step 2.
The timer begins when the SET button is pressed, and
after passage of the time set in step 7, the screen
management program will begin operating.
34
En
Power standby mode
Screen management
function ends here
Power Inverse
standby image*
mode
10 minutes
:
REPEAT
:
01H00M
EXIT
MENU
:
REPEAT
:
00H10M
EXIT
MENU
10
When finished with the setting, press the MENU
button to return to the normal screen image.
Note
The [SCREEN MGT.] setting affects all input sources.
Energy saving settings
(ENERGY SAVE)
The power control function allows screen brightness to
be suppressed as a means of lowering power
consumption and reducing display deterioration.
MENU
5/∞
2/3
SET
Display operating panel
1
Press the MENU button to display the menu
screen.
MENU
PICTURE SCREEN
:
CONTRAST
:
BRIGHTNESS
:
R.LEVEL
:
G.LEVEL
:
B.LEVEL
:
H.ENHANCE
:
V.ENHANCE
PICTURE RESET
2 Use the 2/3 buttons to select [OPTION].
MENU
PICTURE SCREEN
LANGUAGE
ENERGY SAVE
SCREEN MGT.
ORBITER
MASK CONTROL
AUTO SET UP MODE
AUTO FUNCTION
AUDIO OUT
MENU
2/3
SET
5/∞
Remote control unit
INPUT1
SETUP OPTION
0
0
0
0
0
0
0
INPUT1
SETUP OPTION
:
ENGLISH
:
STANDARD
:
OFF
:
OFF
:
ON
:
INACTIVE
: OFF
:
FIXED