Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
tion) and the actual execution of the commands of all the automation units
associated with the scenario.
04. Confirm with "OK".
The icons associated with the scenarios just created will be available in the
main screen "Scenarios".
4.9 - Editing or deleting a scenario
01. In the submenu "Scenarios"
02. To edit select "Edit" then resume from paragraph 4.8 - point 03;
03. To delete, select "Delete" then confirm by selecting "YES" and pressing
"OK".
4.10 - Disabling a command in a scenario
01. Turn on the touch screen keypad, touch the icon
in the main screen;
02. Touch
, the scenario you wish to edit and then "Edit";
03. In the appearing screen, touch "Commands";
04. Touch the automation unit you wish to disable and select the empty box
(----);
05. Confirm with "OK".
4.11 - Running a scenario
01. Turn on the touch screen keypad, touch the icon
in the main screen;
02. Touch the icon of the scenario you wish to run.
If the scenario envisages the arming/disarming of an alarm, you will be asked
to enter the access code.
4.12 - Programming the 4 shortcut keys
Each of the 4 shortcut keys (fig. 2-h) can be associated with a desired com-
mand out of those created.
01. Turn on the touch screen keypad, touch the icon
mations"
in the main screen;
02. Scroll through the icons using the scroll bar to the side;
03. Touch
and then "Shortcut keys ";
04. Select the key to be configured (fig. 13);
05. In the next screen touch:
"Type " to select None, Scenario, Group or Automation Unit.
, touch
and select the scenario;
and then the icon
and then the icon
and the icon "Auto-
"Name" to select the command/
automation in the list of scenar-
ios, group or automation units,
respectively.
"Command" to select the spe-
cific command to be sent (not
available if a scenario had been
selected previously).
06. Confirm with "OK".
Repeat the procedure to create the
other keys.
To edit, select the key once again and resume the configuration as stated
above.
To delete, select the key and in the "Type" function, set "----".
4.13 - Reset
Resynchronises the touchscreen with all the stored radio devices.
Warning - Operation to be performed only in case of radio communication
anomalies.
01. Press the "Reset" button for 6 seconds;
02. Confirm with YES to complete or NO to exit.
4.14 - Executing automation units in automatic mode
Up to 10 timers can be configured to command automation units, scenarios
and groups automatically (fig. 14).
For the configuration, follow the steps below:
01. Turn on the touch screen keypad, touch the icon
select the icon
in the main screen;
02. Select a timer in the list.
In the screen (fig. 14), touch:
"Name" to write the name associated with the automatic execution;
"Enabled" to enable the automation unit execution;
"Event" to configure the automation, the scenario or the group to be com-
manded.
13
, scroll down and
English – 9
Publicité
Table des Matières
