Vitamix C Serie Manuel D'utilisation page 15

O P E R AT I N G I N ST R U C T I O N S
7. If the mixture stops circulating, you may have trapped an air bubble. To resolve,
insert the tamper through the lid plug and stir until it "burps". If this does not work,
press the On/Off switch to stop the motor. Remove the container from the motor
base and use a rubber spatula to press the air bubble away from the blades. Return
the container to the motor base, replace the lid and continue blending.
8. Take proper care when handling and processing hot ingredients and when making
hot soup and sauces.
9. Due to the machine's speed, processing times are much quicker than with standard
appliances. Until you are accustomed to the machine, time things carefully to avoid
over-processing.
10. After pressing the Start/Stop switch to stop the cycle, wait until the blades stop
completely before removing the lid or container from the motor base.
Dry-Blade Container
Your dry-blade container should be used only for hard, dry materials, such as grain, and
for kneading dough.
Before using this container with Programmes or the Variable Speed option, always begin
with the Variable Speed Dial pointing to the Stop Symbol ( ) at the top of the dial.
1.
Load the container before placing it on the motor base.
2.
Fasten the 2-part lid securely. Always use the complete 2-part lid when blending
(unless the tamper is inserted through the lid plug opening).
3. With the motor off, set the dry-blade container on the motor base by aligning it over
the centring pad. Never attempt to put a container onto an operating motor base or
to operate a motor base without a container properly in place.
4.
To begin, make sure that the On/Off switch is in the On position.
5.
Use the Variable Speed Dial to select a function.
• Variable Speed – Rotate the dial to the right to Variable Speed 1.
• Programs – Rotate the dial to the left to the desired program.
6. Activate the machine by pressing the Start/Stop Switch. Your container will shift and
align itself.
• Variable Speed – slowly increase the Variable Speed to the desired speed.
• Programs – The program blending speeds and duration vary and will stop
automatically at the end of the program. Programs can be interrupted by
pushing down the Start/Stop switch at any time. If reactivated by pushing
down the Start/Stop switch, the program will start at the beginning.
15