Clean Air; Sufficient Volume Of Air; Adjusting Air Pressure; Digital Pressure Gauge Version - Sagola 4600 Xtreme Manuel D'utilisation

24/25
Open the product regulator until the appropriate
Fig.9
amount of product comes out. Now you have the
maximum spraying width (spraying pattern). You can
reduce this according to your needs by closing the
spray width regulator.
OK
Please be sure that you put the spray gun properly
by keeping its perpendicularity to the piece to be
painted in order to achieve the maximum transfer
of the sprayed product and obtain the best finishing
quality (Ver Fig.9).

11.1.- Clean Air

The air used for spraying must reach the gun free of impurities, aerosols, oil, silicone and solid
particles. To do this you must eliminate these with coalescent filter units.
The use of air treatment equipment with built-in pressure regulators is recommended (Models
SAGOLA 5200X, 5300X or 5300X Plus).

11.2. Sufficient volume of air

A sufficient volume of air can be supplied to the gun by means of an air compressor of adequate
power (1HP equals 110 L/min approximately), a good compressed air network and by avoiding
pressure drops through the use of antistatic, silicon-free air hoses with a minimum inside
diameter of 8 mm. and resistant to the spraying air pressure (minimum 20 bar) and to the aggres-
sive effects of paint solvents. Before assembling the air network, you must check on the air
tightness of the hose.
Use antistatic air hoses. Should an antistatic air hose not be available, you must attach the unit
to a ground connection in order to eliminate any static electricity.
The total derivative resistance must be <1 million ohms.

11.3. Adjusting Air Pressure

11.3.1.- Digital Pressure Gauge Version

The gun leaves the factory ready to work at an input pressure of 2 bar. In
order to change this adjustment, turn the flow regulator clockwise until the
pressure indicated in the internal pressure gauge coincides with the required
working pressure.

11.3.2.- Analogue Pressure Gauge Version

The gun leaves the factory ready to work at an input pressure of 2 bar. In
order to change this adjustment, turn the regulator control, clockwise in
order to reduce the pressure and anticlockwise to increase this, until the
pressure indicated in the pressure gauge coincides with the required working
pressure.

11.3.3.- Version without Pressure Gauge

The gun leaves the factory with the internal flow regulator fully open. In
order to adjust this to the required pressure, turn the regulator clockwise to
reduce the inlet pressure and anticlockwise to increase this.

11.4. Amount of Product to be applied

Once the product to be applied has been adequately diluted, turn the Product
Regulator clockwise to reduce the amount of product and anticlockwise to
increase this.
During application, the amount of product applicable in areas that are small
or difficult to access can be reduced by reducing the pressure applied with
one's finger.
ENGLISH